Vacuum Infusion

Vacuum infusion pulls resin through dry reinforcement under vacuum, so the laminate is compacted before it is wet out. The result is a higher and more consistent fibre fraction, lower void content, reduced styrene emissions and far better repeatability than hand lay-up, at a moderate tooling cost.

上传图纸 —— 24 小时内报价  申请 DFM 评估

加工能力

我们做什么

Dry fibre preform with resin drawn under vacuum

Dry fibre preform with resin drawn under vacuum

Fibre content 50–60 % by weight with low voids

Fibre content 50–60 % by weight with low voids

Sandwich laminates with foam or honeycomb cores

Sandwich laminates with foam or honeycomb cores

Reduced styrene emissions

Reduced styrene emissions for a cleaner shop

Consistent thickness and weight part to part

Consistent thickness and weight part to part

Suitable

Suitable for structural panels and load-bearing parts

材料

材料

Glass and carbon reinforcement
Epoxy and vinyl ester resin
PVC, PET and balsa cores
Honeycomb sandwich cores
Aramid hybrid fabrics
Infusion-specific resin systems
技术规格

关键规格

项目参数
Quantity50–1,000 parts per project
Fibre content50–60 % by weight
Void contentunder 2 % typical
Thickness control±0.3 mm on flat panels
Mould prep10–15 days for a service-ready mould
Max part sizeup to 4 m
表面处理

表面处理与后加工

Gel coat or in-mould primer

Gel coat or in-mould primer

Paint-ready sanded surface

Paint-ready sanded surface

Clear coat over carbon

Clear coat over carbon

Bonded machined inserts

Bonded machined inserts

常见问题

常见问题解答

Infusion or hand lay-up?

Infusion costs more to set up but gives a stronger, lighter and more repeatable part, so it pays off from roughly 50 parts upward or whenever structural performance is specified. Hand lay-up remains cheaper for one-offs.

What can go wrong with infusion?

Dry spots and voids usually come from leaks or poor flow media placement. We validate the lay-up and flow strategy on a first article before series production starts.

Can infusion make structural parts?

Yes. Infused laminates with engineered fibre orientation are used for load-bearing panels, and we design the stacking sequence to your stiffness and strength targets.

准备开始您的{service}项目了吗?

今天就发送图纸 —— 24 小时内获得经 DFM 审核的报价。

立即获取报价